Jeff Loffert

All
17 posts
89 comments

Replied on Brad Goodman - Cutting and Welding Nitrogen Cut Parts

16 Sep 17:22

Brad Goodman Thanks Brad.👍

Reply

Commented on Matt Hayden - Woodheater Build (Part 3) | Finishing The Build

15 Sep 00:49

Great project, and nice job guys!

Reply

Commented on JD & Jody Talk up Dual Shield Flux Core

14 Sep 16:40

What gas are you running when welding DS with the Lincoln Outershield that JD mentioned? Great info guys, thanks!

Show replies (1) Reply

Commented on 2F Tee Dual Shield 1/4" Steel 25 volts 250 ipm

14 Sep 16:21

I'd like to try DS on my ESAB Rebel 205 AC/DC, but it has no DS settings that I can find in the menu. Forgive my ignorance, but can I simply use it in the standard GMAW mode, and set the volts/wire speed/inductance manually, that way the gas solenoid works as normal? I'll assume that I should use the knurled flux core drive wheels as well? 

Show replies (2) Reply

Commented on Brad Goodman - Cutting and Welding Nitrogen Cut Parts

14 Sep 16:11

Great video Brad! Are you ganging the 12 bottles of N, due to the shear amount of cutting you do on that 5'x10' table, or is it to prevent the 95psi from dropping while cutting?

Show replies (2) Reply

Commented on Brad Goodman - Aluminum Boat Hull Repair

09 Aug 01:24

Real nice repair, and explanation of why you did it. Good work!

Reply

Replied on Sam Hagan - Line Boring Measurements

09 Jul 20:03

Sam Gotcha, thanks Sam!

Reply

Commented on Brad Goodman - Advanced AC Machine Settings (Part 2)

29 May 01:41

Really helpful info Brad, thank you!

Reply

Commented on Brad Goodman - Basic AC Machine Setup (Part 1)

29 May 01:16

Great explanation of how AC frequency affects heat input. 👍

Reply

Commented on Sam Hagan - Line Boring Measurements

29 May 00:54

In cases where welding on a casting is problematic, is boring the hole out oversize, and install a cryo'd sleeve in a hot casting an option?

Show replies (2) Reply