That’s amazing.

I’m pretty sure there’s a couple videos on here from Johannes about it.

That’s pretty slick

Interesting stuff. I’ve read some of this in Metals And How To Weld Them, but the way you explained was a lil easier for this dummy to understand. Thanks.

Some of that is common sense, I think. He said in the previous video that he was going to use an 1/8” bit. And if the metals thick enough to groove, go ahead and groove it.

Sure glad these calls are a thing. I always enjoy them. Lotta times I don’t have time in the evenings to get in on the whole thing, so I’m glad these recordings get posted as well. And nobody minds a little story that’s off topic either lol. Keep up the good work.

Thanks for your sacrifices lol both of these videos are down right uncomfortable to watch. The puddle was a wreck. I’ve never tried using stick on aluminum, but I know a guy that did. Pretty similar experience for him.

Hi. That sounds pretty interesting! Your English is pretty good too 💯😂

I didn’t, but I don’t know for sure if my notifications are on.