Had a BBW bite the dust today! 😔 Sadly I was hanging the torch on the torch holder and bumped the table with the edge of the cup, Pop!

Be careful setting our torches down, even on a holder, too fast or hard.

Be sure to wipe down your filler before you use it! It might look clean but it’s not! Hard to get a clean weld with dirty filler.

Some Titanium for you guys! Welding in a round “plug” over a 1” hole. This is a 2 pass weld. First pass is smaller which seals up the joint then a larger cover pass to burn it in good. These are all purged on the backside with full pen.