More tools from Sam and Matt finishes his SXS fan housing!
Joey Collier
Smyrna, GA, United States
Posted
Posted
Nwe videos from Jody and Matt!
05:31
MIG Chart Settings
Using the mig chart recommended settings can save you time...
Posted
A new one from Jody to start your week of with some welding
07:54
AWS D17.1 Tee joint fillet ...
A tee joint is normally considered to be an easier weld test...
Posted
Last night's podcast is up! Lots of good questions and answers in this puppy.
01:39:12
WS Podcast - Sam, JD, Aren ...
Sam, JD, Aren answer tons of questions in this installment....
Posted
WS Podcast with Sam, JD, + Aren tomorrow 8 pm est!
Posted
New content from Jody Short Circuit MIG and Walking the cup practice!
04:18
Walking the Cup Practice Be...
You can get some practice on walking the cup using plate if...
Posted
A couple new short circuit 2F mig videos from Jody posted today!
02:39
1/4" 2F Lap Joint Short Cir...
2F Lap joint on 1/4" thick cold rolled carbon steel using gmaw...
Posted
New week and a new video from Jody. More on the way
03:19
3F Tee Joint MIG - short ci...
3F tee joint fillet weld on 1/4" cold rolled steel using .035"...
Posted
New one from Brad. Last night's podcast will be up later today with more to come after that!
08:01
Brad Goodman - Anodized Alu...
Today we're working on a boat part repair made of anodized...
Posted
Going live again tomorrow at 8 pm EST. JD and Sam this time! For all the new folks, use the buttons on the stream page to get notified when the stream starts.