DZ

All
5 posts
49 comments

Replied on I’m reading the Hobart Pocket Welding...

Feb 29 at 12:12 PM

No problem, lots of good information in that little book!

Reply

Replied on Welding up my SWAG Offroad Tube Rolle...

Feb 28 at 12:03 PM

Thank you!

Reply

Posted

Feb 26 at 09:25 PM

I’m reading the Hobart Pocket Welding Guide and read up on metal cored MIG wire. Pretty interesting stuff for the right application. Fusion and penetration vs short circuit solid wire is impressive. Would be cool to see a topic on this if the staff thinks it’s worth it.

2

Commented on Down & Dirty Tip for TIG Welding Aluminum Tubing

Feb 26 at 02:04 PM

Great information and thought provoking.  Thanks Jody

Show replies (1) Reply

Commented on I finaly decided to try some intercoo...

Feb 20 at 12:24 AM

Kill it Bob! Man, I don’t know shit, but I’d suggest buying some 4” or 8” flat aluminum coupons (tee joints, lap joints, butt joints, edge welds) and weld those bad boys until you can’t get it wrong….and then move to more complex stuff. It will pay in the long run. Weld metals online has them.

Reply

Posted

Feb 19 at 10:02 PM

1 / 2
2 / 2

Welding up my SWAG Offroad Tube Roller using my new weld positioner...it took a minute to get it....like playing the drums!
2

Commented on Sam Hagan - Rollback Truck Repair

Feb 19 at 05:49 PM

Great stuff in this brief one.  Thanks Sam!

Reply

Commented on Matt Hayden - Arc Force Setting for Stick Welding aka Arc Control or "DIG"

Feb 19 at 05:42 PM

Interesting stuff Matt!  Thank you

Reply

Commented on 3f Tee Joint Dual Shield 1/4" Steel 25 volts 250 ipm

Feb 15 at 08:07 PM

Welds like butter!  I love FCAW-G.  You know it's going to be a good, strong, weld if you do your part.

Reply

Commented on 3F Lap joint Dual Shield 1/4" Steel 25 volts 250 ipm

Feb 15 at 08:00 PM

Good stuff!  Thank you Matt

Reply