JODY COLLIER

Sep 10 at 10:17 AM

I think padding beads and switch hands every bead is a good drill with any rod.  I would start with E70 filler rod on a piece of 1/8 to 1/4" thick. switching hands makes you think harder about what is going on

Isaac aka @ICWELD on instagram uses  7/70 pressures....7 on acetylene and 70 on oxygen and I am pretty sure he said he mainly either uses a 000 or #1 tip for everything using those pressures.  He is one of the best at using a cutting torch I have seen. here is a link to one of his youtube videos where he talks torch tips. https://youtu.be/RQrvIOut6wg?si=3BXE3oDJaNHA_cSq

hi Richard, I try to list settings in every video but I guess I left them out of this one. I just uploaded an updated version of  the video  and edited the description to include settings of 18-19 volts and 200-220 inches per minute with .035" er70s6.  A more recent video using 18 volts and 200 inches per minute worked pretty well.   thanks for catching the omission

jody

Hi Richard, thanks for signing up and thanks for your question.

On carbon steel, there is a pretty wide range of flow rates that will work without giving tell tale signs of not enough or too much gas flow.

but when you have too little, the puddle might start to spark a bit, the tungsten can erode, and you will probable see the puddle bubbling and showing porosity.

too much gas for a giving cup size might cause hard arc starts and might also actually draw air into the argon causing some of the same symptoms as not having enough argon flow.

since there is quite a wide range in between, using more argon than needed will still work but just wastes argon .

hope this helps,

jody

Aug 07 at 07:04 AM

I would go to the chart and make sure you start with recommended settings for the gas you are using and for .030 wire.  The recommended wire speed for .030" on the chart is most likely a bit too high so I would reduce it by 10% to start.  Then its just a matter of welding some beads on scrap to dial in the smoothest arc for the application.   hope this helps.

jody

Reply

Jul 23 at 02:49 PM

Matt and I did a talk on pulsed MIG a while back  https://welderskills.com/programs/pulse-spray-zoom-edit   

We can definitely do another one to cover some of the topics you listed

Reply

Jul 17 at 11:03 AM

thanks very much..and to echo Joeys comment... Let us know if there's anything we can do for your students!  happy to do a zoom call 

Reply

thanks for the insights, gives me an idea for next time

We keep learning.  thanks Martin

Jul 15 at 08:51 PM

you will notice a big difference in arc starts using either 2% lanthanated or CK LaYZr and the tip will hold up much better

Reply