Finally took time to get my spool gun installed. Only downside is (provided I installed correctly, I went by Lincoln’s directions and even they stated this) it seems the wire feed on the front of the machine has no effect on the spool gun and the only WFS adjustment is a numberless dial on the back of the gun. But hoping to run some test beads in a couple of minutes!
Edit: attached are the first beads I’ve run with it. Never touched a spool gun before and this is on just some old scrap 1/4 aluminum plate a customer had me remove and I kept. Running about 10cfh on argon, E setting on my machine (A-G settings) and no clue on wire feed. Machine called for 400 for .035 4043 on 3/16 so I just guesstimated it and dialed it down a bit. Any advice?