Been wanting a cart to store sheets of steel, and also get to with ease. Made it out 2" boiler tube and some 1/8 plate I had laying about. The wheels were also salvaged from the scrape bin, a piece of equipment was beening thrown out so I took the wheels from it.
The tubing was mitercut with the evolution saw "works good but hard to get the round miter cuts lined up for the perfect fit" also hard to get exact length". The sheet was with the slugger circ saw , fresh evolution blade was used since I tortured tested the original with half inch plate bevels. Saw works cool, straight cuts , no dust, no sparks. Chalk line work good to snap lines across the sheet try the blue powder level four.
Welded up the tubing with 6011 3/32 just because a had some. 85 Amp was too hot but did the job , honestly this was a hack job, but I'm happy it's done, it holding a ton of steel I had tucked away and I can easily roll it out now. For what it is it works fine 💪 .